INSTALLATION OF RISER DECALS

The Decals are made of heavy duty vinyl that has been laminated for a high level of protection. The decals come in 48" x 71/4 " but can be easily cut with a utility knife or scissors. Before installation of the decal, the surface must be cleaned with an ammonia based cleaner. They should be pre- cut to fit prior to installation. Remove the backing and expose the self adhesive sticky side. Apply them to your riser carefully moving from one end to the other. Once applied use a rubber scraper or your fingers to get all the bubbles out. If you would like them to stay on permanently apply heat with a hairdryer being cautious that your are not getting to close to the vinyl. If for any reason you choose to remove them from your riser, simply apply heat again and they will peel off.